Making a nail stand for hands
Those who are professionally engaged in the services of a manicure, understand how important it is to have a palm rest. This not only increases the prestige of services, but also makes the manicure process more convenient for both the client and the master. Since the lamps come in different sizes, a pair when buying standard coasters, you can not guess the size. The advantage of self-manufacturing stand allows you to perform it exactly to the size of the lamp, as well as select the desired fabric color. In addition, it is much more profitable to do it yourself, as this will save a lot of money.After the glue has dried, the three shields that you have pulled together need to be sanded. It will be convenient to do it with a grinder, as it is much more difficult and longer to grind by hand. The ends of the shields can also be leveled on the planer. At this stage, the main task is to make three identical shields, and bring them to a smooth state.Next, for a more beautiful view, you can round the corners of the shields. To do this, make a piece of cardboard so that all angles are the same. Using a pencil, mark on the curve the curves, then cut them with a jigsaw.You also need to make the walls of the stand. Since the height of the lamp is 10 cm, the height of the walls can be made 11 cm so that the lamp can freely enter inside. Walls can also be assembled from slats. The width of the walls should correspond to the width of the boards, that is, 16 cm. In the end, you should have 5 parts:
Making a manicure standNow we will look at how you can make a smart stand made of wood that will cost at least 2000 in a store rub. Even if you buy the material, you will spend no more than 500 rubles for independent production.In this case, the stand was made for a lamp size of 20x15x10 cm. Therefore, to begin with, it is necessary to take 35 cm long poles and glue them together with PVA glue. Our task is to make three identical plates 35 cm long, and 16 cm wide. The thickness of the rails can be 10 - 15 mm. After you glue the slats into the shield, you must tighten them with clamps and wait a while until the glue hardens. Cut slats of the required length can be using a jigsaw.
- Lower shield;
- Upper shield;
- Shield , which will be covered with a cloth;
- The left wall;
- The right wall.
How to improve health
Cheap wedding dresses from the collections of democratic brands
High-quality and inexpensive kitchen furniture
Romance with a Married: Survival Instructions
Horoscope for the week from 9 to 15 April
How to make an Easter bunny
How to understand a young man
Babulino dress Volochkova mocked fans