Shoe dryer

All faced in the winter with the problem of drying shoes. Dryers for shoes are heavy, but the most common is the central heating battery.  Shoe dryer
The only question is how to install shoes. I propose to make the dryer from the remnants of the laminated floor (incidentally deciding the issue of using scraps from laying laminate). Advantages of this design: fasten directly to the battery side, not the top; the possibility of mounting one dryer over another (with two dryers), which saves space; It is easily disassembled for the summer, in disassembled form occupies very little space. Laminate trimming was used with a thickness of 8 mm. For the manufacture you will need: - the remains of laminate; - ruler, pencil; - jigsaw; - electric drill, drill with a diameter of 8 mm; - emery cloth, file; - varnish or paint, brush. Dryer consists of two racks-holders, internal locking plate, external locking plate,two wedges and screen-support.
 Shoe dryer
 shoe dryer
shoe dryer
Shoe dryer
 Shoe dryer
 shoe dryer
Shoe dryer
To simplify assembly there is an ancillary kit included.
 Shoe dryer
The rack-holder is the main element of the structure, has a complex configuration, so its Dimensions are given in three figures, so as not to clutter the drawing. The entire structure is assembled without the use of glue and other fastening devices, such as self-tapping screws and the like. However, there are cross-shaped connections (half-wood overlay).
 Shoe Dryer
Making it simple.Mark up the sample in the right place. At the end of the sample in the middle we drill a hole with a diameter of 8 mm - the thickness of the laminate. Use a jigsaw on the inside to cut out the selection.
 Shoe dryer
If necessary, adjust the file. The laminate has a durable waterproof coating on both sides, but the cuts will swell under the influence of water and ruin the structure . Therefore, all cuts must be painted over or varnished.
 Shoe dryer
Since the laminate fastener does not play any role, we don’t pay attention to it. Getting down to the assembly. Auxiliary bar connect with racks.
 Shoe dryer
Holding the supporting bar with one hand, slide the lower C-shaped parts of the racks into the first and fourth intersection openings, counting from the edge. With the other hand, we install the internal locking bar through the central section opening so that it enters the C-shaped grip.
 shoe dryer
Tightening the auxiliary bar and set the outer striker on top.
 Shoe dryer
While the drying is moving, we determine its place at will with upward movements and down. Install wedges.
Shoe dryer
Remove the auxiliary plate. Insert the support screen.
 Shoe dryer
Between the screen and the battery you get a space where you can put your shoes sock down.

Related News


Composite pool at the dacha - the secrets of its construction
Painting weights as a souvenir
How to stop jerking off
Features of making ice fish
Vegetable preparation for the winter recipe
What is diluted vodka
Animal Faces from Pompons
What jackets will be fashionable in 2015 (13 photos)